93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIRE™ serial access EEPROM. Datasheet – production data. PDIP8 (BN).

Author: Arashizil Gosho
Country: Luxembourg
Language: English (Spanish)
Genre: Travel
Published (Last): 20 August 2014
Pages: 101
PDF File Size: 13.52 Mb
ePub File Size: 4.85 Mb
ISBN: 174-6-50016-231-8
Downloads: 66349
Price: Free* [*Free Regsitration Required]
Uploader: Samuran

I CC read Read current. The status signal is not available on DO, if CS is held. Data output delay time. Low level output voltage. T SV is relative to CS. When it is connected to. Chip select low time. If CS is brought low during a program cycle, the. After power-up, the device is automatically in the.

93C86 Datasheet catalog

The Serial Clock is used to synchronize the communi. All Programming modes must be. This gives the controlling master.


Chip select hold time. Microwire is a registered trademark of National Semiconductor.

8K/16K 5.0V Microwire Serial EEPROM

Data bits are datzsheet clocked. For proper operation, ORG. Data input setup time. Temperature grade is marked on line 2. Opcodes, address and data bits are clocked in. Under such a condition the voltage level. The ERAL cycle is completely self-timed and. A0, the higher the voltage at the Data Out pin. Dimensions D and E1 do not include mold flash or protrusions. On those devices, programming is always enabled.

93C86 PDF Datasheet浏览和下载

The WRAL command does include an. Once the EWEN instruction is executed, program. Low power CMOS technology. Word-selectable devices such as. All inputs and outputs w.

These clock cycles are. All modes of operation are inhibited when V CC is below.

93C86 Datasheet(PDF) – Microchip Technology

This pin allows the user to enable or disable the ability. DO at logical “0” indicates that datashete. DO at logical “1” indicates that.


Mold Draft Angle Top. START conditionwithout resulting in any device.

Program Enable pin to write protect the entire. For added protection, an EWDS command. Execution of a READ instruction is independent of.

If status is checked. Sequential read is possible when. A high level selects the device; a low level deselects. BUSY status during a programming operation.