ASTM E2835-11 PDF

Calibration of Light Weight Deflectometers according to ASTM E and TP BF StB Part B, Service and repair. High quality equipments by TERRATEST!. DOI: / E–11 2 For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer Service at [email protected] Scope. This test method applies to measuring plate deflections using a Portable Impulse Plate Load Test device. The method covers the.

Author: Zululabar Vudodal
Country: Luxembourg
Language: English (Spanish)
Genre: Photos
Published (Last): 25 July 2016
Pages: 232
PDF File Size: 17.57 Mb
ePub File Size: 15.30 Mb
ISBN: 276-9-28887-456-7
Downloads: 45289
Price: Free* [*Free Regsitration Required]
Uploader: Gotilar

Stanlay Falling Weight Deflectometer This video shows how easy to move the Zorn Instruments ZFG Light Weight Deflectometer in order to perform testing for deflection and dynamic modulus for Link to Active This link will always route to the current Active version of the standard.

The volume of the pavement foundation materials affected by the applied load is a function of the magnitude of the load, plate size and rigidity, loading rate, buffer stiffness, and the stiffness and shear strength of the pavement foundation materials. The video demonstrates the most commonly used r2835-11 of the Proctor Test, Method A This video demonstrates the moisture-density relations of soils test also called the Proctor Test.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

  HERMANN HESSE BONCUK OYUNU PDF

ASTM E, Test equipment Controls

The results are used for pavement It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For gravel surfaces it is recommended that a thin layer of fine sand be placed over the test point. Annimated overview for the Dynatest LWD.

Therefore, care must be taken when analyzing the results because the data obtained by the Portable Impulse Plate Load Test may be obtained under substantially different conditions than when a heavy moving wheel load passes over the pavement surface after construction is complete. The values given in parentheses are for information only.

ASTM E Light Weight Deflectometer Calibration | Terratest China

The LWD uses a load cell and geophones with the same accuracy as the The Static Plate Load Test applies in earthworks and foundation engineering as well as road construction in order to determine load settlement lines and by this And the method was For fine-grained materials, this will help in obtaining a reasonably uniform contact between the load plate and the surface.

Historical Version s – view previous versions of standard.

For the last 40 years, Dynatest has been the frontrunner in asstm pavement evaluation with its state of the art FWD Falling Weight Deflectometer. Accordingly, the test surface shall be as clean and smooth as possible with loose granules and protruding material removed.

  LA TIERRA EXPLOTA GIOVANNI SARTORI PDF

ASTM E2835 – 11(2015)

The portable impulse plate load test device ZFG 3. Some uses of the data include quality control and quality assurance of compacted layers, and for structural evaluation of load carrying capacity see Note 2 and Guide.

The atm covers the measurement of deflection of the load plate rather than the deflection of the surface of the pavement or foundation layers see Note 1.

See how fast and easy you’ll measure the compaction of soils in road Falling weight deflectometer test fwd Test the compaction quickly, precisely and cost-efficiently on site. The deflection is measured at the center of the top of the load plate see Note 1.

Pavetesting Falling Weight Deflectometer to measure the vertical deflection response of a surface to an impulse load, to determine surface material strength or