LK201 C200H PDF

Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Dirg Kagarr
Country: Iraq
Language: English (Spanish)
Genre: Music
Published (Last): 26 June 2018
Pages: 205
PDF File Size: 10.25 Mb
ePub File Size: 11.65 Mb
ISBN: 692-9-38987-807-3
Downloads: 33632
Price: Free* [*Free Regsitration Required]
Uploader: Bazuru

Edited 16 Nov by sokhanh. You need to be a member in order to leave a comment. Pin 3 on the back may be the problem depending on how your custom application was programmed. With the information you have provided, there is no way for us to tell. I have tried with an ch-lkv1 but everything is the same. You’ll need to tell us in more detail what you have done. Posted 13 Nov Welcome to the Forum!

On the CPU, led “run” is green.

Omron Ch-lkv1 Host Link Unit | eBay

The restriction is strictly mechanical. Sign in Already have an account? Share this post Link to post Share on other sites. Last week, the cpu couldn’t power on, so I have replaced with a new CPU.

  KEHLMANN DIE VERMESSUNG DER WELT PDF

Neither of them are V1’s. Started by sokhanh13 Nov Sign In Sign Up. Posted 22 Nov The 25 pin connector would run into the lk021 of those peripheral units if you used these slots.

Omron C200h-lk201-v1 Host Link Unit

No electrical or logical restriction for using these slots with CH-LK But there’s still no RCV light Please help me! One of the other old school guys l,201 have to answer this one.

Edited 15 Nov by sokhanh. Posted 13 Nov edited. The PLC configuration does not matter. As far as using the peripheral port It determines if addressing is required in the event of a muli-link system. I have checked the cable carefullly, the cable should be ok. I also tried with this cable LK Coputer Posted 21 Nov Posted 15 Nov Thank you for your explaination, I have tried ok201 pin 3 on the back OFF but still cannot conect.

If your application is not sending an address and a calculated FCS then it will not communicate with pin 3 set to ON. This is common Omron serial settings. If it is not blinking then you have a bad connection. C200n the command level is set for a custom application for full read and write. Thank c200hh for your reoly! Help me with ch-lk Started by sokhanh13 Nov PCMRthat Data will have to be reentered into the appropriate locations. After revisiting this I found conflicting information in the manuals.

  JIROFT CIVILIZATION PDF

By the way, can you tell me the different between lkV1 and lk? All the configuration is done with the LK switches.

Be careful what you plug into it. I will check the cable one more time!

Omron CH-LK (CHLK) – Axdos AB | PLCSWEDEN | Automation Spare Parts

On the older ones, it c20h0 only intended for the hand held programmer. If possible, which cable I have to use? What is the part number of your back plane?

This is basically the same as the rack mounted unit you have. The DIP switch front are 0;0;5;2 back are off;off;on;off;0v Please help me!